Check it out.
This is a listing for a Kossel 3D Printer.
reprap.org/wiki/Kossel
I have purchased enough nuts and bolts for this printer and another (included). I also have everything that is needed to finish the printer in a labeled box.
All you have to do is buy it and wire it and then calibrate. It has auto leveling too! This printer will be able to print PLA. If you wanted to print in ceramic or wood or nylon all you have to do is purchase an all metal hot end. This will print 1.75mm PLA I will even include an extra roll of filament to get you started.
Zero backlash.
Type: Delta printer
Speed: 320 mm/s in all 3 directions.
Resolution: 100 steps/mm in all 3 directions.
Repeatability: better than 0.03 mm (30 micron)
Build volume: cylindrical, 170mm diameter, 240mm height.
Footprint: triangle, 300 mm width (240mm OpenBeam + printed corners).
Frame height: 600 mm.
Print surface: unheated round glass, doesn't move.
Mass of end effector with hotend: less than 50 grams.
Simplicity: fewer than 200 parts.
Fully automatic print surface level calibration (autoleveling).
The printer is about 80% complete. Let's give this printer a nice home!
Let me know if you have any questions!
9 years, 5 months ago