World's Most Wear Resistant 3D Filament

Email yourself a 10% off coupon

Send

Coupon sent! Check your email

posted in Community by nvantol

Hello Everyone! If you are looking for a 3D filament that has very good wear characteristics, igus, Inc has just unveiled their newest Tribo-Polymer product. Check out the technical data at the link below.

http://www.igus.com/wpck/11723/N14_4_1_iglidur_TriboFilament

You can even request a free spool of filament at the bottom of the page! Happy printing.

9 years, 10 months ago

elpulpo - I got my sample yesterday. Very impressive stuff! It came with a load of very slippery injection moulded samples. Thought I'd put a few inches through my printer. Just to see what happens. Unfortunately it was set TOO HOT!! Just extruding, it came out all crinkly and crumbled in my hand. I'd be interested to see whatever y'all can make from it. BTW. Also checked the price. Be sure to be sitting down when you ask!! :-D

9 years, 10 months ago

elpulpo - I was just asked about the sample so thought I'd put up a little more information. The sample of Tribo filament is roughly 10 Metres, so enough for a medium-sized Emmett geared bearing. That's certainly what I'll be making with it, once I gain control of my extruder temperature with one of these...

http://www2.artaylor.co.uk/store/index.php?route=product/product&path=57&product_id=55

And the cost will be............wait for it..............$300 bucks a Kilogramme. :-D

9 years, 10 months ago

sonumonu91 - Share this post http://gta5moneyonline.net

3 years, 8 months ago