Enhancement pack for the rcexplorer.se canopy for the tricopter mini. Skids Rear spacer base for level installation 2.3mm spacer (for original canopy rear spacer holder) Non-conductive board camera mount Antenna mount (holds 3mm plastic bowden tube) For more room for the lipo: Nose spacer 8mm off-set Nose spacer 10mm off-set 8mm spacer 10mm spacer 12.3mm spacerPrint all parts from ABS, 0.1 layer height, solid. For the Non-conductive board camera mount: Drill holes to 2.5mm and use a M3 thread tapping tool to cut threads into the mount. If possible use M3x20 screws to secure the mount. For the spacers you will need longer screws than supplied by RCExplorer.se as the screws need to be longer to get a good grip on the original 40mm spacers. I'd recommend cutting M5 (inner diameter 3mm) aluminium tubes to length instead of printing the spacers. For the antenna mounts: Use M3 plastic tube and feed the antennas through the tube to protect them from the propellers. Use CA to glue the mounts to the side panels. If using a GoPro, make sure that the antennas do not get into the view of the camera.