About: ===== 3D printed case for the Proxmark3 - a software defined RFID reader swiss army knife. https://github.com/Proxmark/proxmark3 Files: ===== case.stl - the bottom part of the case. lid_print.stl - the lid and button lid.stl - just the lid button.stl - just the button. OpenSCAD files are included.Print instructions: ===== Print out case.stl as is. No support should be necessary. Print out lid_print.stl or lid.stl + button.stl. lid.scad will need flipping upside down if you want to print it, lid_print.stl has this done already. Personally I used black for the case, clear for the top so that the LEDs can still be seen and blue for the button, but it's your choice :) Fitting instructions: ===== Fit the edge of the board under the ridge on the far side then push down on the port side of the board to wedge the board into place. If it doesn't fit easily, lightly file the inside of the case and/or check your printer's calibration :) If you have difficulty getting one side of the lid in place - use a scraper or guitar pick between the snap and the slot while pushing down on the lid, then withdraw the scraper.
- 0 inches x 0 inches x 0 inches
- this product is 3D printed
- 16 available colors
- material is a strong plastic
- free delivery by May 03
- 0 parts