Fed up of all those square cases? I decided that some curves are in order for my Panelolu 2 LCD case. Check out the update for touch button interface http://northernhope.blogspot.co.uk/2014/01/panelolu-2-capacitive-button-interface.htmlPrinter Brand: RepRapRepRapPrinter: Huxley #710Huxley #710Rafts: Doesn't MatterDoesn't MatterSupports: NoNoNotes: Printed on Borosilicate glass to obtain a polished finish though not necessary for printing of the part.Instructions Print the STL files, one of each. Settings detailed below. 1) Calibrate your printer for dimensions 2) Print 1 of each STL files in different colours perhaps 3) Use 3.0mm counter sunk screws to reataint two halves Background There are some quite nice cases on Thingiverse for the LCD display modules. But they are in the main boxy! So a curvy case was needed to house LCD module and the associated electronics which is a little softer on the eye. We don't need the controls etc.as Huxley #710 has a dedicated computer with standby UPS. The case is designed to fit the PCB and retain it using small screws on small standoffs. 4 posts are provided designed for 2.5mm screws. The case accepts 4 off 3.0 mm screws which can self tap into the opposite half Derivative changes N/A Design For Manufacture Assumes 0.50mm nozzle and prints on a 140mm x 140mm bed. The display shown in the image is a Radio Spares (RS) 720-0226 Fordata FDCC2004B-FLYYBW-51SE. Safety Take care if using sharp tools. Sample Part Manufacturing Technical Documentation Printer : Huxley #710 (RepRap Pro) Firmware : Marlin 1.0.0 RC2 - 15 Feb 2013 Software : RepRap Pro Software 811708f - Pronterface Material : PLA - Faberdashery - Arctice Whilte Material Dia. : 1.75 mm (Msd 1.80 mm ) Nozzle : 0.50 mm Layer height : 0.25 mm Layer width : 0.6 mm Extrusion T : 198 C Bed T : 60 C Feed Rate : 28 mm/s Perimiter rat. : 0.5 Infil pattern : Hexagonal Infil solidity : 0.15 Cooling Fan : No Bed material : Borosilicate Glass Over hangs : Yes Support : No Design For Manufacture Parameters Model : Absolute dimensions Scale : 1:1 Holes : Yes Layer height : 0.30 mm Layer width : 0.6 mm Over hangs : Yes - 45?° usually not an issue Support : No Model Tools Function: Model Fix up Tool: NetFab Studio Basic Version: 4.9