Wade stile extruder Parts for Tilt Printer excluding hot end, will fit on a cupcake with ABP All respect to WadePrint out: 1 Off each - M8_Extruder_Block_45deg_MODv2, M8_Extruder_Idler_Block_45deg_Modv1, WadeGear_43Teeth_New_tooth_profileBuild as per normal wade but use 4mm tension springs by drilling holes in the Block and Idler block to depth you need then use small screws to capture spring end, will design holes in future but away from home atm.Ohh small hole at top for spunge, havent tried it yet,, duno,, hot end being difficult to fit 45 deg angle having to go back to original wire type due to angles.