For as many iPhone stands as I've seen on Thingiverse, I never saw one that was just like this -- holds the iPhone in a portrait orientation while allowing you to charge it, and fits the iPhone 4 models and earlier (the wider charger port). Maybe there is one and I just couldn't find it in the sea of similar designs. So I designed my own. This lets me set my iPhone in a position that works well for it to work as an alarm clock while it's still plugged in so it's charging overnight. That's all. Doesn't try to hold the charge cable in place or anything, it just lets you feed it up into place and that's that. (Best thing is to pull it up through, connect to the phone, then drop it back through as you set the phone down.)Probably a good candidate for printing with a brim since there's a fairly large number of layers and a fairly small bed-touching surface area. Otherwise, nothing special is required. Fishing that cable through is a bit tricky at first but have patience, it can be done. You will probably need to carefully trim and clean and file first though, if your printer leaves any hair or schmutz.