I printed 4 of these small body post extensions that fit over the existing 6mm body posts to highten the body by about 10mm or so. You should be able to easily modify the Autodesk Fusion DWG or STL file for your preferred length. I chose not to print any holes in this for the body clips because you might need a different orientation for the clips. Holes are easy enough to make with a 2mm drill bit and some patience. The flex of the existing body post should be good enough to prevent the extension from breaking. Also added a few simple 6x16mm rings, although PLA is probably too hard to cushion the flex.Print 4 extensions and 8 rings.