21st March 2016 --- Updated: I have Dugout, polished, revamped a website I have been lying there for almost two years. Finally, I had spent sometimes puzzled it up. Hope it looks simple and illustrative. Please visit my new site -- http://www.designique.co for all MagSavior Products and my new Google Cardboard Variant (pending google certify)Have you ever encountered your MagSafe power adapter for the MacBook was blown away suddenly one day and you have to buy another one? Have you noted that the joining part of the adapter and the cable have a kink inside? That is because the negative shielding has worn off. (See my photo attached!) Thus, will create lots of electrical stress onto the adapter and one day you will hear the "POP" sound. If your MagSafe is still working and wish to prolong the life span before googling "How to fix MagSafe adapter". I have made this little clip that is able to strengthen the flexible end of the joining part between the cable and the adapter. I am pretty happy about it and wish to share with everyone out there and hope everyone have a Safe Magsafe. Updates: Check out my FaceBook Page: https://www.facebook.com/DesigniqueCo Print ABS with infill 15 - 20%, shell =2 and layer height 0.2. Please scale 1.02 as the fitting will be too tight with original size. Adjust according because i've found that my 80W and 65W adapters are different in cable thickness. I have attached photos to explain on the installation of the cable saver. PLA might be too brittle ... btw, the thru hole on the flank is a 4mm dia and you can use a Cable tie to tighten the grip. Do give me some feedback if you have any. Thanks :P