I abolished the ABP for my TOM. The aluminum build surface was prepared instead. However, the aluminum plate had the weak grip to melted ABS filament. I solved the problem using the metal primer. 1.A aluminum plate is cut in the size of 120x120x1mm. 2.To make six holes. 3.A panel is washed with a detergent. 4.Sanding by the #120 - 240 sandpaper. 5.The metal primer is painted. 6.Waiting for 30 minutes. 7.It attaches to TOM.If the performance to grab becomes weak, it will perform from 'No.4'. Removed from the plate to cool (less than 60-70deg) the parts. The remove is recommended to use the cutter.