Filastruder Electronics Enclosure v3 & Hopper Funnel v3 (Based on the original by Tim Elmore)

Email yourself a 10% off coupon

Send

Coupon sent! Check your email

I added "Filastruder", "MAIN", "MOTOR" script to the front panel, vents along the top, angled support for front panel. As well as a screw down tab on the left side. This holds down the Sestos controller perfectly no need to fasten it to the Enclosure or the wooden support. Fits #8 screws on all holes (I used the same diameter screw holes as Tim's design). I did remove the front right upper hole as I was not sure the purpose of it. The Hopper has a tapered bottom, instead of being flat. Instructions are the same as Tim's: ** Tim's did not need support. I printed it in ABS, but it would probably be better in PLA.

Filastruder Electronics Enclosure v3 & Hopper Funnel v3 (Based on the original by Tim Elmore)

View files

Delivery address

First name

This field is required.

Last name

This field is required.

Email address (for your receipt)

Please enter a valid email.

Country

This field is required.

Street address

This field is required.

Apt, suite, etc.

City

This field is required.

State

This field is required.

Postal code

This field is required.

Pay with credit card or debit card

or pay with

Card number

Expiration

CVC

Place order

Order summary

Filastruder Electronics Enclosure v3 & Hopper Funnel v3 (Based on the original by Tim Elmore)

Color:

Quantity:

Subtotal

Delivery (May 02 - May 04)

Free

Total