PLEASE READ CAREFULLY THE BOTTOM OF THIS DESCRIPTION FIRST ! This is an attempt to create a 3D sculpture out of the famous "Screaming Hand" design from Jim Phillips, a famous designer for Santa Cruz skateboards. Note that it's an "attempt" which means it's not accurate and far from perfect... Modeled with Meshmixer and Sculptris. For more information please visit http://www.reppersdelight.spacymen.com/index.php/post/2013/10/14/Screaming-Hand-3D-sculpture SKATE or DIE !!! Edited : I also uploaded the left hand for those who want to print a model that is closer to the original design Edited : I have intentionally deleted the files for download because after reading things here and there I'm just afraid I might have done a copyright infringement. Sorry folks ! I know I should have think about it before but honestly as I am not a lawyer it didn't jump to my mind at all. And as I can't afford a lawyer (I don't even have a job...) I prefer to not take any risk. I'm just going to contact Jim Phillips first and might reload the files only if he is OK with that. I hope you understand... ===========================================================EDITED after receiving an answer both from Jim Phillips and NHS. And here is the answer : "Ambrose, your 3-D print of the Screaming Hand is amazing, however, according to NHS inc, it is not OK to post the 3D printed sculpture as this is an infringement to make, or allow others to make, any reproductions of the now Globally Trademarked Screaming Hand design." - Jim PhillipsAT ALL THE PEOPLE THAT DOWNLOADED IT : Please don't post that thing again here or anywhere else. If I find out that it has been uploaded back I will ask Thingiverse to make sure to suppress it ASAP ! AT JIM and NHS / SANTA CRUZ : Thanks for your replies and sorry for all the trouble. ===========================================================This thing is the :thing that I published so far.FREE 3D PRINTING OR DIE!I haven't 3D printed it yet and I bet someone will probably do it before me... Print it either in ABS or PLA with support. The sculpture should be able to stand on its base. Happy printing !