This is one of my characters from my past thesis called "The Little Pastry Chef". She is the Gramps' granddaughter aka the Princess! I finally got around to making her print ready. Between a quick re-pose, dynamesh & decimation, she's lost some of the finer details but I did my best to retain enough information to get a good print. She's about 4 inches tall. *Take care in removing support attached to her hair strands. Use a tweezer to get into the tiny areas to remove support.Printed on my Afinia H-Series 3d Printer with these settings. 4 hours 9 minutes. Quality Normal Resolution 0.15mm Part Settings Angle: 30 Deg Surface: 2 Layers Fill: Hollow Support Settings Dense: 2 Layers Space: 8 Lines Area: 3mm Angle: 30/40 Deg