This file is the cutting pattern for this leather Camera Case, which is designed to fit a point and shoot camera that's 97mmW x 62mmH x 23mmD. The case is designed to be hand stitched together with ease, as the stitching holes are lasercut to ensure perfect, evenly spaced stitching. The design is for 2.5mm Russet leather, although thinner leather can be used. The photos show the engraved version of the camera case, but the engraving design has been removed from the design file, so you can add you own pattern. The file does not include the strap.To complete the case you need: • 10mm rivet if you’re making a strap and using 2.5mm leather • Snap dome (you will need a washer to pack the shank if you’re using thin leather • Thick industrial thread (double layer)Assembly notes: It’s easiest to start the stitching at the opening, sew down to the bottom corner and reverse back to the opening. This will make it easier to tie the end knot. Length of the thread should be about six time more than the seam length.