Remix of magicaltrevor's "Wrist Gear for standard servo mount for Inmoov rotating wrist" I created this due to printing problems with my Replicator2 (Overhangs and internal structure). I have successfully printed this Part with my R2, but have not yet tested it with my servo or in the full assembly. Stay tuned for updates! I hope you don't mind magicaltrevor, ant thank's a lot for the original design!!! And shoutout to the inMoov Project!!! -- 18.11.2013 - UPDATE Updated the Part to adapt hairygael's original top gear. Thank's for the input! Part is printed but not assembled. Made with: Replicator 2 Infill 30% / Shells 3 / Layer Height 0.2mm / No Rafts / No Supports / Build Time 16min / Weight 2.47g 22.11.2013 - UPDATE Updated the height and the diameter of the bottom (servo) gear to better fit my standard servo. The part should now fit a 5.9mm Servo gear. However, when you print this part in PLA and put it on a plastic servo, you might get problem with the traction of the servo assembly. Whit a metal servo you should be golden. Made with: Replicator 2 / PLA Infill 30% / Shells 3 / Layer Height 0.2mm / No Rafts / No Supports / Build Time 14min / Weight 2.17gThis Part is a derivative of the lower Servo Gear of the original inMoov Project Wristgear3.stl. For instructions please visit: http://www.thingiverse.com/thing:25149