This thing was inspired by "Desktop Christmas Tree Star Topper" uploaded by marvec6. I took that stl, and revised it so it could be printed in two halves and glued together to make a whole. Note this is a small tree topper. 118mm wide.I used 1 shell and 15% infill, no supports are required. You will probably have to sand the two mating surfaces prior to gluing (due to slight warpage at the extremes), or perhaps glue and then use filler such as spackle or silicone prior to painting. I've added .sat, .stp and .igs files which are 3d solids files (three different file formats) for those who wish to experiment.