An Earbud Holder to keep your earbud cables neat and tangle free, designed to fit all sizes and styles of in-the-ear earbuds including those with control modules as used on the iPhone. For an EarPod holder designed for the newer Apple EarPods, go to http://www.thingiverse.com/thing:598228 and for a holder designed for the older Apple Earbuds, go to http://www.thingiverse.com/thing:13678.Drop the earbuds in the recesses and start wrapping the cable by bringing it down and under the lip to the right, then up again, catching it in the right slot, then left and over the buds and down through the left slot. Hold the spooler and wrap the cable until the jack is close to the farthest hole it will reach. If it won't quite reach, unspool about a half turn, insert the jack, then roll the loose cable over the bottom lip, using one of the slots if it won't fit over the whole spool. For earbuds with a control module on the cord, start wrapping the cable by bringing it down and under the lip to the left and use the bottom slot to bring the module to the rear and across, then back through the opposite bottom slot to continue wrapping the cord. (See the photo.)