I extracted the mesh from the Skyrim game engine, but it was a really low detail model (image #2), so I recreated the model using ZBrush in very high detail. You should probably only print this if you have a good resolution printer for best results (I don't use the makerbot printer, I use the Form1 SLA printer, which prints this perfectly). The model is hollow to save on material. If you do end up printing this on your FDM printer, let me know how it turns out! You might even need a decent computer to open the model, it's 1.8 million polys, so keep that in mind when working with this. I spent a lot of time modeling this, but it still belongs to Bethesda, so don't go around selling this.There are two different models, one with a base and one without a base.