I wanted to print a robber for my 3D-printed Catan set, but why just replicate the plain pawn that came in the original set, when you can make anything? andreas's Hitman seems like a good robber, when you scale him down and give him a little base to stand on. Sadly, the act of importing the STL into SketchUp, resizing, adding a base, and recreating the STL makes a very very very large STL, but it's still a usable one. NOTE: I have not been able to successfully print this due to spindly elbows and such, the need for support, etc. If anyone is able to get it to work with anything other than dissolvable filament, please comment about how, and post an I Made One picture!I have had no luck printing this because of how spindly and thin some parts are, plus the extensive need for supports. This probably can't be printed at this scale unless it's done with a dissolvable support filament. If anyone succeeds, PLEASE post a Made One picture and some information on how you got it to work. Even if you get it to work, I bet you'll lose the silencers, but that's okay, robbers don't need silencers anyway.