After seeing the Onix and Geodude featured here on Thingiverse by user ClassyGoat a little bit ago we decided to make another popular Pokemon 3d printer ready! Vaporeon! This print is going to need to be printed WITH supports! Based on the 3d Pokemon Models Project at http://roestudios.co.uk/project/3d-pokemon-models/ Pokemon Copyright Gamefreak/Nintendo Edited for printing by: Nate L. Using Blender If there are other Pokemon from the site you would like to be made 3d printer ready please leave your suggestions in the comments! This model has to be printed with supports! The stack in front of the head is to ensure better print quality at the end of the print where the tip of the fin on Vaporeon's head gets very tiny. This model should be fine to print at .3mm layer height or lower. Have fun while printing!