Complete redesign of my universal Wade with some Improvements. Should fit all Printer with 50mm Mounting holes ( V9 Hotend only testet on uniX-Carriage and Orca)additional FeaturesFeature Removed:I made a Prusa uniX-Carriage for test purpose http://www.thingiverse.com/thing:25600 Update 01.09.2012:Shoppinglist Main parts:1x M8x50/60mm hobbed bolt 5x M8 washer 2x M8 Nut 1x 8x20mm bolt (or a cutoff of a M8 bolt) for the Idler 2x M4x60mm screw 2x M4 washer 2x M4 Nut 2x spring for Wade (~ 5mm diameter and 10mm lenth, depending on its strengh) 3x 608 bearing 3x M3x30 screw (one for the idler two for the inset) 3x M3 washer 4x M3 nut 1x M3 worm screw (?) 4x M3x10mm Screw (for Stepper mounting) 2x M4 Nylock nut`s for mounting the wade 2x M4 Screw , lenght depending on the Carriage you are using.Additional parts for Mendel-Parts V9 / V10: 1x 28x32x2mm thick metal plate, cut and drilled to fit into the printed "carrierplate" and then drill the holes 1x M6 brassnut 2x M4 Nylock nut 2x M4x15 screwFor 1,75mm filament printing you need a brasstube with d=2,4mm / D=3mmPrint all Extruder parts and the Inset of your Hotend.there are two version of the insets, one with 16,7mm for well tuned printer, and one with 16,4mm for not so well tuned printer ;)*I Uploaded pictures to show how it is assembled (would take me too long to write all down, sorry guy`s)*For Reprapfab/Geeksbase Hotend you need to rasp the screws square and press them (from left to right) tight to the hotend when mounting. the important corner is on the upside of the hotend (Pictures show only the lower side !)For Mendel-Parts Hotend on the original plate you have just to print the inset. First mount the Hotend on the carriage (use a additional screw beneath the plate) and then put on the Extruder.* For Mendel-Parts Hotend on uniX-Carriage you have to make a small iron(or steel) plate (28x34x2mm). -Print the "carriertemplate.stl" and put the plate into it to mark where the holes should be drilled at. Make the middle hole about 7mm and the outer 4,5mm. Iron Plate is not needed anymore, just print the new short V9 inset (maybe a second time for filling the hole on the upper side) and screw it tight between two nut`s (like shown on the picture) ensure that the indentation of the inset stands in the right directionadditinal pictures can be found here: http://imageshack.us/g/6/unixwade15.jpg/