This will be 3D printed near you and delivered to your door by May 02
Loading
I designed this monitor bracket to fit an old lamp post I had. It will fit any 38 mm diameter pipe. Here are a couple videos of my build:
http://www.youtube.com/watch?v=Y_j2_TrbmLohttp://www.youtube.com/watch?v=yeJCa7_OSB4You may want to print the pipe clamp bracket with exterior supports. I did not and had some sagging on the underside of the hinge. The monitor bracket is designed to fit standard monitor bracket holes with 10 cm spacing. My particular monitor did not have a recessed square area for the bracket. This bracket might not fit monitors with a recessed mounting area with out adding some kind of spacers. Parts needed:
2 lengths of 5/16" threaded rod
4 5/16" nuts
4 large 5/16" washers
2 small 5/16" washers
1 old floor standing lamp post
1 cheap LCD monitor from the pawn shop