An accessory for the Adafruit's Prototyping Pi Plate http://www.adafruit.com/products/801 for the Raspberry Pi. The OpenSCAD parameters can adjusted to fit difference thickness of PCBs, if you want to use it on another board.These are plastic clips that can be used to add additional support, so when you push wires into the board, it does not bend and damage the Pi connection pins.Designed to be cut out of acryllic using a laser cutter.More: http://todayimade.co/items/joe-walnes-made-laser-cut-raspberry-pi-clipsCut these out with a laser cutter. I would recommend acrylic plastic between 3mm and 6mm thick.Use the .dxf file if you just want to use it unmodified. If you want to make dimensional changes, or make more/less, use the .scad file and OpenSCAD.Note: The slots are slightly different sizes (the Adafruit PCB is slightly thicker than the Pi PCB), so you may need to flip it around if it doesn't fit the first time.