I wasn't able to find a smiley i liked on thingiverse so i made one myself! The world needs more smiley!! hahah..Just download and print! Version 1: Mr. Smiley with cut away face. Print using any single colour thread. Yellow is strongly recommended. =DVersion 2: Mr. Smiley with Extruded face. Intended for the 'face' portion to be printed with different colour threads. The thread lengths required for version 2 are as follows: base layer: 724mm [yellow recommended] face layer: 155mm [black recommended] Length values are obtained using default settings in slic3r. Check out your own slicing program for more accurate lengths.visit http://richrap.blogspot.co.uk/2011/06/multicolour-3d-prints-and-3mm-filament.html for suggestions on how to print multi-coloured parts!Version 3: Pencil/Pen Topper as suggested by mattwj2005 I'm not sure of your pencil diameter, but mine is 8mm. I made the smiley 10mm thick and the hole diameter 9mm at the edge, decreasing until 5mm in the centre. (I kindly request anyone that prints this to post a picture! =))Notes: Designed in Solidworks. Have uploaded the original Solidworks file in case any one wants to modify it. The different versions are stored in different configurations of the same file.