BGRL-HA02A Apparently Thingiverse likes toilet roll holders. This is yet another speculative - and if I may say so myself, slightly weird - design for a batchelor-friendly toilet roll holder using the same spline fitting as the previous BGRL-H01A and it's more functionally evolved form, the BGRL-H03A. By batchelor-friendly, I mean that if there was a carrier tube to remove or otherwise require the user to do something other than just remove the roll then the roll would never be changed. So this design allows the user to just slip the spent roll off the carrier tube with no additional effort. This was adapted from the aforementioned BGRL-H01A by slicing off one of the arms and re-manipulating the left arm to support the load of a roll by itself. That has lead to slight size tolerance issues for the roll. I might alter the dimensions later but it appears to work right now. Use with BGRLM-M01A (wall mount). Optional accessory: TPRS-M01A prevents toilet roll sliding around carrier tube. Version History: V1 - original Build time / particulars: ~ 3 hours in Standard mode on Makerbot 2. No supports needed.