This is a Stand for the Panelolu LCD ( http://www.thingiverse.com/thing:28332 ) which also carries the Sanguino 1.3a board itself. I designed this because my "Beiwagerl" Printer is too small to mount the Board onto it ^^ I recommend to change the connectors to one who are straight or bend them to show upwards (except the heater connectors) but it will also work with the connectors in normal position.Add two connectors to the 12V rail between the stepper connectors to attach the fans (2x50mm)Exchange the actual case screws with 40mm one`s Print both feet, and put them on the Sanguino board. then push the stand through the LCD-Case screws. then lift the board a little bit to get the LCD-cable through between the LCD and the board. Then fix the stand with three additional screws.