Needed a way to keep the cubes accessible and organized. This uses the same design as my quadcopter blade box except with curves to allow you to remove the cubes. The 2 decks with the game need a discard pile each so I needed 4 deck holders that could fit into the space of 2. Included are the SolidWorks files for all the parts except for the partbox-single.STL. This is because I just cannot get SolidWorks to agree with me on making the curve. The box I used for that was one of the early prototypes so I didn't have the original SolidWorks file.You probably want to print with an extrusion width of 0.505 so that the inner walls are solid instead of having a slight gap. Also I find it best to print all this with a 3mm brim and just clean up with an xacto knife. The lid might need a bit of filing. You want it snug but not tight and not too loose.