Another item for intended for givaways at airshows, maker fairs & science events. Printed at 0.5 scale. I added a thicker tailfin (for the smaller scale) to limit snapping it off, and rocket exhausts. No support or raft required for the scale printed at. The rocket exhausts might need support if printed larger - I deliberately did not extend them out too far to get away without support at a smaller scale. The source for the remix was from BonsaiBrain, Thanks! 3mm PLA @ 200 Centigrade. Sliced 0.3mm with 25% fill. Printed at 0.5 scale. I used a small brass brush to get rid of the stringy PLA fluff after printing them off four at a time.