An OU logo slider and football tips to make a bolo (or western, or string) tie so you can show off your sooner pride and still be dressed up. I'm not completely satisfied with the tips yet, but I've gotten frustrated enough with the software in trying to create a cleaner version that I'm going to roll with these for a bit.Print OU.stl in crimson (or red will do) and a pair of Football-tip2.stl's in cream (or white will do). The cord is On a Cord brand rounded, braided lace, 3mm x 40in, in red (I think white might be better), #4958769. Any braided leather cord should do, though you may have to modify the ID parameter to the holder module in OU.scad and the d parameter of the cylinder in Football-tip2.scad. This required a bit of clearing inside the holders to get the cord through, but it needs to be tight enough to stay in place. Finally, glue the ends of the cord into the holes provided in the two footballs.