This is a little sleigh I made for a Lego Santa mini figure I have.. the lego bumps are a tiny bit off but will snap in with a little effort.I also made one without lego bumps for use with the Makerbot man or any other small figures.I added the shortened Connectors so that it can print on smaller build platformsPrints without support and just snap together.I printed mine with an infill of 15% and a layer hight of .20mm with 2 shells.. thought it should print fine with default settings.The harness to sleigh connection is a bit tight but I did that so it wont fall off once it's connected. use a pair of pliers to squeese the end to make it fit if nessary..I used some left over filament to make the reins but you can use string or what ever. it's also fine without reins.