This is a cover/bezel for my USS-96-12 Cavalier Coke machine, which is from sometime in the early 70's. I am not sure you can get replacement parts like this anymore... originally this is a chromed metal part that uses bendable tabs to secure it to the front panel. I have included two models, one with, one without tabs. I think using silicone to glue the bezel on may be better than trying to use the tabs as the manufacturer did. But mine isn't broken and I am not going to risk trying to remove it to see which way would be better. I included the 123D Make source file if you want to customize it. This was in response to a request from OrangeHokieFan, over on my other Cavalier thing (the puck), as his is missing. Enjoy!I have not printed it, as mine isn't broken... however I think maybe a good metallic spray paint finish over a sealing/filler spray (the one you get at the auto parts store that fills in scratches and small gaps) would be the ideal way to get something that somewhat resembles the original. The original one isn't a work of art or anything - it's obviously a cheap pot metal sand casting, mass produced. So don't be too critical of your printed part. It might look better than an original anyhow!