I had a hard time slicing the ancestor object in Slicer for my Printrbot's 0.5mm nozzle, so I took it into Tinkercad and made the walls fatter. While I was in there, I made a lid. The resulting object works, but careful, because they fit together almost too tightly! Not sure how I will get it off :/Print out two halves. Put your Digispark inside. Snap shut. Done. Possibly regret not having a good way to get it out again…If you have a finer nozzle - consider using the ancestor, Digispark Board Holder/Protector. Made with Tinkercad. Feel free to copy and do your own mix:https://tinkercad.com/things/hOnaN56BXbQ-digispark-container