Not sure how many out there might have one of these but if you do you know the wall adapter for the commercial Kenwood HT's is a heavy little brick and takes up a lot of space. So i made a quick wall bracket for it so i can mount it down under the shelf the radio charger sits on to free up space. Could be adapted for many other similar large power adapters so i thought it would be useful enough to upload. It has gusseted screw brackets on all four corners. I printed this with 25% infill and it seems plenty sturdy, but two of the feet cracked slightly at the screw holes from me overtightening the screws, if i would have increased the infill to 50-75% it would have easily fixed that problem, but even at 25% it takes the hefty weight of the power adapter no problem whatsoever. I added openings to the sides to allow good airflow to prevent it from overheating and it works great! Print with support and at least 25% infill, 50-75% would be better to make the screw brackets more resilient to cracking from over tightening the mounting screws. If you print it on its side so all the faces are vertical the openings print better with support in the middles. I tried printing it mounting feet down and the top opening sagged a bit and it used a ton more support.