Needed a cabinet to keep my Arduino parts in. Everything I found online was too small. This project will push your printer to the limit (at least mine). The cabinet is 5 5/8' deep, 5 1/2" tall, and 8 5/8" wide. (Not including the handles.) Additionally, the drawers are .1" thick on all sides so they could hold some weight. This used a lot more PLA than I thought. I might redo the drawer thickness sometime down the line. NOTE: By request, added the 123dx files (source files) so this thing can be edited to your preferences.My printer has a published print volume of 6" by 6" by 9". Because of this, I did not do any rafting, just printed directly on the plate. Print times were 14 hrs for the cabinet and 7-8 hrs for each drawer. I printed the cabinet on it's back. The DrawerX.stl refer to the number of bins in each drawer. NOTE: The cabinet has a top and bottom. I have placed small bumps in the front corners of each level to stop the drawer from being pulled all the way-out accidentally. If the drawers won't go in, flip it over.