After someone mentioned the idea of a head tracker mount i redid the snapon mount to accomedate two servos (pan,tilt) This is modeled from a generic 9g servo found on thingy so the fit might be alitle off depending on your servo off choice. Still searching trough my servo list to find one that fits like a glove, if you find the one please lett me know. The other side of the servo is ment to have two 7,5mm bearings fitted with a shaft off choice glued in the middle. Still havent found any bearing that would work so might have to widen the holes to fit yours. Other than that you just have to drill out your own spline size in the camera holder. Camera holder has room for 11mm thrust bearing.