A case designed for the Fadecandy LED controller. This suits board fc64x8 Rev B, with 0.1" headers soldered, as sold by Adafruit. This case has a slide in lid which requires no screws. There are two files for the base, one with tabs to suit M3 screws and one without. When printed in white ABS, the LED is still visible through the case. Product link (as of 22/12/14): http://www.adafruit.com/product/1689 UPDATE 28/12/14: Reduced width of lid after issues with it being too wide to fit into the base (thanks donwulff). Revised lid file to Rev 1.1.Printed on an UP! Mini, Fast speed, hollow infill, White ABS. Designed with Formz 8 Free, cleaned up with netfabb basic.