A remix of flameblade's Crest of Hyrule. I wanted a standing version of this print, but didn't want to print it standing up. The details of this lovely design come out much better if you print it on it's backside so I opted to make the supports separate bits. I didn't think it was much of a change compared to this overall awesome design, BUT flameblade still noticed :). & I'm not stingy, so rather than have him attempt to redo the work, I'm posting the edit up for all. It will stand up without the bits, but tips quite easily. If your display surface is unstable or not level you can print these small leg bits to keep it firmly planted! .. of course.. there's always double-sided tape ;) Print the Crest. Print the Bits. Combine the parts.