Still working on this, needs a few tweaks to get it just right but the idea is there. Uses the LCD holder from Gadgets3D LCD mount for Prusa i3 Modifies it by adding a single piece hinge assembly and a keyway into the base part which allows the display to tilt up and down and rotate for easier viewing at different angles. Known issues: Pin is slightly too small, nut recesses on base too small, base holes are too small. If there is enough interest I will update the design and post new files. Update 18/1/05 This version should assemble better.Printed at 30% infill, designed it so no support material is required if printed in supplied axis (assuming you print on a PRUSA I3 that is)