I chose the croydex twist 'n' lock to mount my bathroom things as I had just re-tiled and wasn't sure of the location. Now that I am sure and the looks have grown on me, given that the twist and lock needs tightening every 6 months I just made something to use 3m command strips to semi-permanently mount the things. It will probably work fine with other twist 'n' lock products but that is untested. Feedback welcome. New V3 uploaded, longer thread. I cant get the thread to print correctly as it is very fine but the metal nut part cuts it correct anyway.Printed at 0.2 layers height, 15% infill and 3 shells. In case anybody cant figure it out, stick the thing on the wall using the command strip. The flat part should be roughly horizontal (and towards the bottom). Totally unscrew the twisting part of the croydex holder until the sucker falls out. Then put the bog roll holding part over the thread on the thing and and use the twisty part to cut a new thread into the plastic thread. Do not over tighten, you shouldn't need to, you want the main body of the croydex to just about contact the wall. Other croydex items may need to be held tighter to avoid rotation, for those I would suggest 2 sticky pads, there should be room. As with all command strip products the clue to strong adhesion is time. Leave the strip on the wall for a few hours before attaching the croydex, then leave a few hours before hanging your prized bog roll on it.