I needed a hook to lower the shower basket in my shower. Rather than use a bent coat hanger, I wanted to try and design a Print in Place hinged shower hook. It holds in place on the shower head using a zip-tie through a small square slot. The design is done in Fusion 360 (file included) and was printed on a Solidoodle 4 using Octave PLA at .2 Sliced and printed with Simply3D with custom supports. A little pressure was all it took to break the hinged "latch" free and it pivots quite freely. I needed a space of .4mm for the hole around the pin, and between the hinge sides. Almost useless, but my first print in place hinged design. :-) Sliced and printed with Simplify3D with custom supports. A little pressure was all it took to break the hinged "latch" free and it pivots quite freely. I needed a space of .4mm for the hole around the pin, and between the hinge sides.