Some vice jaw protectors/soft jaws for a small 60mm hobby bench vice. Use the vice jaw protectors to avoid damaging delicate objects when you grip them.Vice: The small bench vice shown has no identifying branding or markings on it. In order to check if the jaw protectors will fit your little hobby vice, the pertinent info on the jaws is: Printing: The jaws are printed without support. The only overhang is the 45° angle of the clip and that prints without support. Layer height: 0.15mm The sides should be one wall thickness depending on your extruder type. Perimeters: 2 The jaw faces are 0.8mm thick, so if you print with min 3 top & bottom layers, then the jaw face should print effectively solid, so your infill selection doesn't matter.Measure your vice jaw height. There are two .stl files. One with 11.15mm jaw height, and the other with 12.15mm jaw height. Print two of the jaws that match your vice. Use: Snap in place, hold delicate parts with less chance of damaging them. Don't forget you can also add masking tape or similar to the vice jaws (or protectors/soft jaws) if you are worried about damaging the finish of your object.