Looking for a cute and cuddly Calibration Test ?? Look no further,, cause this cat is out of the bag. At only 2.4mm in height, he will stress test your modem speed,, processing power,, software options,, hardware selection,, filament choices, and your patience. It started with a seemly harmless attempt to convert an avatar .jpg to an .stl. I used a very high resolution image (??clue to all problems that followed). This bad little kitty will take a few minutes to download,,, crash most slicing programs,,, and render scaling options useless without at least 16mb ram. And look what he did to my spool of filament?? So,, armed with a new laptop and MatterControl, I was at least able to get a plaque to print. This is the start of a project to bring Duplicat to life,, and in to the form of a toy,, as I learn to use modeling software. =^.^=