http://www.thingiverse.com/thing:702153 NOTE: These mounts are for the Wacom Intuos Pro Tablets. Since initially posting I found that the small, medium and large tablets all are 0.5" thick. So this should work for all the Intuos Pro tablets. Specifically models PTH-451, PTH-651, PTH-651/S, PTH-851 This is a re-mix of my original one. Added some curves to make it more visually pleasing. Ignore the quality of the print in the photos. I printed these at warp speed! I drew this up for my Wacom tablet to open up space on my desk while not in use. Mounts with standard plastic wall anchors. The holder for the stylus is built into the right bracket. You can still connect the charger to it if needed, the charger receptacle is not covered by the wall brackets. If you don't own a 3D printer and would like to purchase, search for these on eBay.