Read more about the daily earring project at #1: http://www.thingiverse.com/thing:7120AE started knitting a few years ago, and I made these pirate-ish earrings for her. This is revision 2 and the files are a bit messy, as back then I did not plan on making daily models...On the prints you can see different print qualities on the UP.For UP!: Print on it's back (better quality, hard to get out of the support) or standing (less stable needles)... Trial and error.//UPDATE:I redesigned it (fixed some errors, repositioned the needles to the center) and made a smaller version that has thicker needles and strings. NEW_5C.stl : Scale 0.3 (almost 42x31x15mm), loose thread on loop down NEW_5C-thick-scaleot0_2.stl : Scale 0.2 (about 24x27x9mm), print with loose thread on loop downwards, don't print with too few supports else it will break easily. Printing standing might reduce the support material, but breaks easier (at least at that scale).On PP3DP UP!: Check "print unsolid model" as it has a few errors (or fix the stl...) 45/45 support angle will make it a bit harder to remove, but it's doable, and reduces drooping. Works with almost all layer thickness and speed setting, .25/normal is a decent compromise of high detail and speed.