All you need to make this work is a pack of 25mm M3 screws and nuts which should be easy to source. It needs 6 screws and 9 nuts as I used two nuts on the pulley screw as a locknut. I set the locknut so the pulley can freely spin, but the original design didn't allow it to spin but works fine - it's up to you. The original nuts, screws, pulley and washer are re-used with the exception of the one that held the pulley in place, I replaced that with a longer one (25mm). If you are careful and secure the fishing line to the reel holder or somewhere else on top then you should be able to swap this for the original wood piece and keep the original fishing line, I managed to do it on all three pretty easily.