Update 15 April 2015: I got tired of having the bushing move down in the holder when pushing the switch, so I added a flange to prevent that. Use Rev A with the flange. I made Thingiverse #3612 for to use with my flashlight. It turns out the flashlight I got (an NRA gimme flashlight) was too small to fit in the clips. This is a bushing to adapt a small diameter flashlight to the desk stand.For Rev A (recommended): Print as oriented Print on raft with supports 0.2 mm layer height, 30% infill For Rev -: Rotate object 90 degrees to build as a cylinder. 0.2 mm layer height, 30% infill