-DailyEarrings & Prologue: www.wap.cc & thingiverse.com/thing:7120The 100 clear wedding decoration "diamonds" from ebay arrived today; They look much better as on the product images. Initialy I intended to color their back in a metal color, as the green one I used earlier has a reflecting aluminum coating. Now I am thinking about testing more colors, if they look just as nice (and not as plastic-y as the photos suggested).Anyway, here are the details! Perhaps I will tinker with this file a bit in the future to improve it :-)Printed on an pp3dp UP, no clue how to on other printers. But it's small, so you might as well try it.1- Print the stone holder 1.1 "standing" or "laying" Printing it on the opening will require you to clean them so the diamond clips in, but printing on the round side will squish it a bit and create a rougher surface.1.2 and low support angle, but make sure there's enough support/raft so it will not come loose!)2- print the earring loop box (scale to 110-120% for better fit!)2.1 The stones will clip into the holder similar to the snake diamond holder, but you need to bend it harder to slide them in. Still carefully!!!After three diamonds are in, snap the holder box in. It's a bit tricky, but should be no problem ;-)