Replacement pad for a small grip/trigger/bar clamp. It always seems we have to loose one pressure pad on our trigger clamps. Here is a printable replacement pad for a small clamp. This pad is approximately 15mm X 21mm and prints without support for a print and use result. I printed this on a Thing-O-matic then lifted it from the heated bed to install on the clamp without any trimming. I did strengthen it with a brushing of acetone to bond the fibers.Directly print the *.stl then, install and use. The sketchup file has two pads. I made one short but, then decided to make a full sized pad. You have both to choose or scale.