This will be 3D printed near you and delivered to your door by May 01
Loading
More communist art! :|I'm really starting to get the hang of cleaning up point clouds... this time I used meshmixer to smooth out a lot of the rough edges. See relet's original thing to get the point cloud I used to make this.This is going to be a tough print and need lots of support...Raft Settings I used for this print:Interface feed rate multiplier: 2.0
Interface Flow rate multiplier: 1.0
Interface infill density: 0.3
Interface layer thickness over layer thickness: 1.3Support cross hatch: on
Support flow rate over operating flow rate: 1.0
Support gap over perimeter extrusion width: 1.0
Support Material: Everywhere
Support Minimum Angle: 46.0Crosshatch makes it really easy to break apart the support structure... PROTIP: wear eye protection - I found out the hard way - OUCH!