This is a bottle cooler shaped to fit Sodastream glass bottles. It was inspired by JamieLaing's Wine Cooler but wanted to have a perfect fit for all the Sodastream bottles we have. I've added some other versions now: No. 5: square outside shape, gives you more space to fill in the ice in the corners. No. 6: like No. 5 but with round edges. No. 7: like No. 6 but with stronger support between the inner and outer wall. No. 7: I've also added another one with no wholes between ice compartment and bottle area. It should keep you bottle dry (not sure if it works; condensation?) but has probably less cooling efficiency. I didn't try it so far. Any feedback would be apprechiated. And finally now there is also a cap that helps filling in the ice. Just put it on the inner circle and drop the ice and some water over it. No more ice will be falling into the bottle area. ;-) For my printer I've had to split the cooler into 3 parts. That's why No.7 helped me as in each part, the inner and outer walls were connected. I've printed the cooler with 50% infill, less would probably be also fine. The ice infill cap can be printed with very little infill.